A flat tyre is manageable with a jack and a spare, as long as you work on level ground and loosen the nuts before lifting.
This guide walks through the process in clear illustrated steps, from the first preparation to a finished result. Each step has its own picture, so you can compare your progress as you go.
How to use this guide
Work through the steps in order. Method 1 of 2 covers the basics, and the later methods offer alternatives and finishing touches. If you only have a minute, skim the Quick steps box above and come back for the details.
Related guides
- How to Stay safe while traveling solo
- How to Add baking soda to a pool
- How to Deal with a flight delay
- How to Press flowers
- Browse all Travel guides
- All 52runoob guides
Trusted external resources
A note on sources
We check each guide against the official resources listed in References at the end of this article. External links open in a new tab; the related guides above stay on this site.
Quick steps
- Park on level ground and engage the brake
- Loosen the lug nuts slightly
- Jack up the car and swap the tire
- Lower the car and tighten nuts in a star pattern
Things you'll need
- A spare tire
- A jack
- A lug wrench
- A wheel chock or brick
Step-by-step
Method 1 of 2: Prepare and Loosen
Step 1: Pull over safely
Move to a flat, solid area away from traffic and turn on your hazards.
Step 2: Set the parking brake
Engage the brake so the car cannot roll while you work.
Step 3: Find the spare and tools
Locate the spare tyre, jack, and wrench under the boot floor.
Step 4: Chock the opposite wheel
Place a block behind a wheel to stop the car moving.
Step 5: Remove the hubcap
Prise off the cover to expose the lug nuts.
Step 6: Loosen the lug nuts
Break each nut free with the wrench while the tyre is still on the ground.
Step 7: Position the jack
Place the jack under the frame point near the flat tyre.
Step 8: Lift the car
Pump the jack until the flat tyre is a few inches off the ground.
Method 2 of 2: Swap and Secure
Step 9: Remove the lug nuts
Take off the loosened nuts and keep them together.
Step 10: Pull off the flat tyre
Slide the flat wheel straight toward you and set it aside.
Step 11: Fit the spare tyre
Lift the spare onto the hub and line up the bolt holes.
Step 12: Hand-tighten the nuts
Screw the nuts on by hand so the wheel sits evenly.
Step 13: Lower the car
Release the jack slowly until the tyre touches the ground.
Step 14: Tighten in a star
Tighten each nut firmly in a crisscross pattern.
Step 15: Stow the flat and tools
Put the flat tyre and jack back in the boot.
Step 16: Drive carefully to a shop
Get the damaged tyre repaired and check the spare's pressure soon.
Tips
- Loosen the nuts before lifting so the wheel stays steady.
- Tighten nuts in a star pattern for even pressure.
Warnings
- Never work under a car supported only by a jack.
- Do not drive a small spare at high speed or for long distances.
Frequently asked questions
How long does it take to change a tire?
What supplies do I need for change a tire?
Is change a tire safe for beginners?
References
- AAA — how to change a flat tire. https://www.aaa.com/autorepair/articles/how-to-change-a-flat-tire
- NHTSA — tire safety. https://www.nhtsa.gov/equipment/tires
- wikiHow — How to Change a Tire. https://www.wikihow.com/Change-a-Car-Tire
Every guide is reviewed against its sources. See our editorial policy.
Reader comments
0 so farFinished this guide? Tell other readers what worked, what didn't, and what you would change.