Printable checklist

How to Change a Tire

A flat tyre is manageable with a jack and a spare, as long as you work on level ground and loosen the nuts before lifting. This illustrated guide covers 2 methods and 16 steps, with a separate picture for every step.

By Co-authored by 52runoob Editorial Team · 16 steps · Travel & Outdoors · Updated November 20, 2026

Back to the guide
  1. 1. Pull over safely

    Move to a flat, solid area away from traffic and turn on your hazards.

  2. 2. Set the parking brake

    Engage the brake so the car cannot roll while you work.

  3. 3. Find the spare and tools

    Locate the spare tyre, jack, and wrench under the boot floor.

  4. 4. Chock the opposite wheel

    Place a block behind a wheel to stop the car moving.

  5. 5. Remove the hubcap

    Prise off the cover to expose the lug nuts.

  6. 6. Loosen the lug nuts

    Break each nut free with the wrench while the tyre is still on the ground.

  7. 7. Position the jack

    Place the jack under the frame point near the flat tyre.

  8. 8. Lift the car

    Pump the jack until the flat tyre is a few inches off the ground.

  9. 9. Remove the lug nuts

    Take off the loosened nuts and keep them together.

  10. 10. Pull off the flat tyre

    Slide the flat wheel straight toward you and set it aside.

  11. 11. Fit the spare tyre

    Lift the spare onto the hub and line up the bolt holes.

  12. 12. Hand-tighten the nuts

    Screw the nuts on by hand so the wheel sits evenly.

  13. 13. Lower the car

    Release the jack slowly until the tyre touches the ground.

  14. 14. Tighten in a star

    Tighten each nut firmly in a crisscross pattern.

  15. 15. Stow the flat and tools

    Put the flat tyre and jack back in the boot.

  16. 16. Drive carefully to a shop

    Get the damaged tyre repaired and check the spare's pressure soon.