How to Sharpen Scissors
Dull scissors tear instead of cut, but a few minutes of sharpening restores a clean edge. This illustrated guide covers 3 methods and 18 steps, with a separate picture for every step.
-
1. Clean the blades
Wipe off dust and sticky residue so grit does not scratch the edge.
-
2. Check the pivot screw
Tighten a loose screw so the blades meet properly along their length.
-
3. Open the scissors fully
Work with the blades open so you can reach the whole cutting edge.
-
4. Find the bevel angle
Look at the ground edge and note the shallow angle you need to follow.
-
5. Secure the scissors
Hold the handle firmly or rest it on the table for control.
-
6. Wet the stone
Soak or dampen a honing stone so it grinds smoothly.
-
7. Stroke along the bevel
Draw the blade along the stone at the same angle as the factory edge.
-
8. Repeat evenly on both blades
Give each blade the same number of strokes so they stay matched.
-
9. Use a file for nicks
Run a fine file lightly over small chips to smooth them out.
-
10. Oil and wipe the blade
A drop of oil and a wipe removes metal debris after sharpening.
-
11. Test on scrap paper
Cut a strip and listen for a clean, smooth slice rather than a tear.
-
12. Wipe away metal filings
Clean the blades and stone so no grit is left behind.
-
13. Try the foil trick
Cut through a strip of aluminium foil a few times to smooth a minor burr.
-
14. Cut a test shape
Trim a small curve in paper to check that the tips cut cleanly.
-
15. Store in a sheath
Keep the scissors in a cover or drawer to protect the edge.
-
16. Keep them dry
Dry the blades after washing to prevent rust along the edge.