Printable checklist

How to Add Baking Soda to a Pool

Baking soda raises a pool's total alkalinity, which steadies pH and protects the surface. This illustrated guide covers 3 methods and 18 steps, with a separate picture for every step.

By Co-authored by 52runoob Editorial Team · 16 steps · Home & Garden · Updated November 18, 2026

Back to the guide
  1. 1. Test the water first

    Use a reliable kit to measure total alkalinity and pH before adding anything.

  2. 2. Record the current reading

    Write down the numbers so you can track how much each addition changes the water.

  3. 3. Check the pool volume

    Estimate the litres or gallons in your pool, since dosing depends on volume.

  4. 4. Use the dosing chart

    Look up how much baking soda raises alkalinity by the amount you need.

  5. 5. Measure the powder

    Scoop the recommended amount with a dedicated plastic cup, keeping it dry.

  6. 6. Turn on the pump

    Run the circulation so the added powder mixes through the whole pool.

  7. 7. Broadcast across the surface

    Sprinkle the powder in a wide arc rather than dumping it in one spot.

  8. 8. Brush the pool walls

    Brush the sides and floor to move settled powder into the water.

  9. 9. Avoid the skimmer area

    Keep powder away from the skimmer so it does not clog the filter.

  10. 10. Let it circulate

    Allow several hours of pumping so the alkalinity reading evens out.

  11. 11. Rinse the measuring tool

    Wash the cup afterwards so residue does not clump for next time.

  12. 12. Retest after circulation

    Measure alkalinity again once the water has mixed fully.

  13. 13. Check the pH

    Baking soda can nudge pH up, so test both readings together.

  14. 14. Adjust in small steps

    If the target is not reached, add a smaller second dose and retest.

  15. 15. Let the water clear

    Wait until any cloudiness disappears before using the pool.

  16. 16. Record the final readings

    Keep a log of the dose and result for the next maintenance round.