Printable checklist

How to Fix Windows 11 Boot Delay After Installing an SSD

After an SSD upgrade, a long boot delay usually means the firmware is still looking for an old drive, the storage controller is in a slow mode, or too many apps load at sign-in. Confirm the SSD is detected in UEFI mode, place it first in the boot order, then enable fast startup and trim startup programs. Updating firmware and drivers, and rebuilding the boot configuration, clears any leftover references to the previous drive. This illustrated guide covers 2 methods and 19 steps, with a separate picture for every step.

By Co-authored by 52runoob Editorial Team · 19 steps · Performance & Speed · Updated November 21, 2026

Back to the guide
  1. 1. Open firmware setup

    Restart the PC and enter BIOS or UEFI setup using the key the maker shows at power-on.

  2. 2. Locate the SSD in storage information

    Find the drive list in firmware setup and confirm the new SSD appears there.

  3. 3. Set the SSD first in boot order

    Move the SSD to the top of the boot priority list so the firmware starts from it first.

  4. 4. Disable legacy boot mode

    Turn off legacy or compatibility support module boot so the system uses UEFI only.

  5. 5. Check the storage controller mode

    Verify the SATA controller is set to AHCI so the SSD runs at its full speed.

  6. 6. Save and restart

    Save the firmware changes and let the PC restart to see whether boot time improved.

  7. 7. Check for firmware updates

    Visit the PC or motherboard maker site and install the latest system firmware.

  8. 8. Enable Secure Boot

    Turn on Secure Boot so Windows follows a clean UEFI path from the SSD.

  9. 9. Verify the drive connection

    Reseat the SSD or check that the drive reports healthy so a loose link is not adding delay.

  10. 10. Confirm the firmware boot mode

    Check that the firmware now reports UEFI mode for the boot device after saving.

  11. 11. Open Task Manager

    Use the keyboard shortcut that opens Task Manager and switch to the Startup apps tab.

  12. 12. Review startup impact

    Look at the startup impact column to find programs that delay the sign-in process.

  13. 13. Disable heavy startup apps

    Right-click unnecessary startup programs and disable them so they no longer launch at sign-in.

  14. 14. Open power options

    Open the power options section of Control Panel and find the power button settings page.

  15. 15. Enable fast startup

    Turn on fast startup so Windows saves its kernel state and boots faster from the SSD.

  16. 16. Test a cold boot

    Shut down fully and power on again to confirm the earlier delay is gone.

  17. 17. Update storage and chipset drivers

    Install current chipset and storage drivers from the maker or through optional Windows updates.

  18. 18. Open an administrator terminal

    Open Command Prompt or Windows Terminal with administrator rights to run boot repair commands.

  19. 19. Rebuild the boot configuration

    Use the boot record rebuild commands to recreate the BCD store pointing at the SSD.